Yeastar 集成—

功能

ITSP template-based trunk provisioning
GUI-driven trunk and route setup
Supports registration and IP-based auth
Per-DID inbound routing rules
Works with P-Series and S-Series

如何接入

Add Cliqtel as SIP trunk

Go to Settings > PBX > Trunks in the Yeastar portal. Add a new VoIP Trunk with provider type "General" or use the ITSP template.

Enter Cliqtel credentials

Set Hostname to sip.cliqtel.com, enter your username and password, and select Registration as the authentication method.

Configure inbound routes

Create inbound routes to map your Cliqtel numbers to extensions, ring groups, or IVR menus.

Test the connection

Check trunk status — it should show Registered. Make a test call to verify inbound and outbound routing.

前置要求

Yeastar P-Series Cloud or S-Series
Admin access to Yeastar Management Portal
Network reachability to sip.cliqtel.com
At least one Cliqtel number

中继配置

连接时将创建一个采用以下优化默认值的 SIP 中继：

transport

udp

codec preference

g722,ulaw,alaw

nat mode

auto

auth type

credentials

max channels

4

接入后核对清单

Trunk status shows Registered in Yeastar portal
Inbound test call reaches configured extension
Outbound call completes with correct caller ID

Yeastar + Cliqtel：应用场景

Replace your current SIP provider

Migrate your Yeastar system from an expensive SIP provider to Cliqtel without changing your PBX configuration — same SIP protocol, transparent per-number pricing.

Add international numbers to Yeastar

Expand your Yeastar deployment with local, toll-free, and mobile numbers in 70+ countries. Assign them to extensions or queues exactly as you do today.

Failover and redundancy

Add Cliqtel as a secondary SIP trunk for Yeastar to fail over when your primary carrier has an outage. Keep your customers reachable 24/7.

Yeastar 集成——常见问题

How do I connect Cliqtel to Yeastar?

Create a SIP trunk in your Cliqtel portal, copy the credentials, and paste them into Yeastar's SIP provider settings. A full step-by-step guide is in the setup steps above.

Does Cliqtel work with my version of Yeastar?

Cliqtel supports all current and recent versions of Yeastar. Check the supported versions list above or contact support if you're running an older release.

How much does it cost to use Cliqtel with Yeastar?

Cliqtel has no setup fees, no monthly platform fees, and no channel limits. You pay only for the DID numbers you rent (from EUR 1.49/mo) and the minutes you use. See our pricing page for details.

Can I use my existing phone numbers?

Yes. Cliqtel supports porting for most countries. Contact support with your existing numbers and we'll check portability and timelines (typically 5-10 business days).

Does Yeastar need any special firewall configuration?

Open UDP 5060 (SIP) and UDP 10000-20000 (RTP) outbound to sip.cliqtel.com. Most PBX systems handle this automatically if you're not behind a strict NAT.

Yeastar

功能